Raymarine GyroPlus Yaw Sensor Einstellungsanleitung PDF herunterladen (Seite 28)

22 SmartPilot X-5R Drive Operating Guide

SPX-5R Drive system alarm messages

If a fault or failure occurs in the SPX-5R Drive system, an appropriate alarm message

is generated.

If this happens and unless otherwise stated, press

standby

to clear the alarm and

return to manual control, before you attempt to resolve the problem. If more than one

alarm occurs, as each alarm is cleared, the next is displayed.

Alarm messages, possible causes and remedies are detailed in the following table.

Navigation information not

received

Navigator not transmitting the correct data. Ensure sys-

tem cables are securely connected.

The SPX-5R Drive system will

not auto advance to the next

waypoint

No bearing to waypoint information received from the

navigator.

Alarm message Possible cause and remedy

CURRENT LIMIT

Serious drive failure – the drive is taking too much current due to

short-circuit or jamming. Check the drive unit.

DRIVE STOPPED

The SPX-5R Drive system is unable to turn the rudder. This can occur

if the weather load on helm is too high, or if the (optional) rudder posi-

tion sensor has passed beyond the preset rudder limits or rudder end-

stops.

Manually check that the steering system operates comfortably and

that it is not being overloaded.

Check drive and, if appropriate, the rudder position sensor..

LOW BATTERY

Supply voltage has dropped below acceptable limits.

• press

standby

to clear the alarm and return to hand steering

• start the engine to recharge the battery

• ensure the charging system is working correctly.

LRN FAIL

(code)

AutoLearn not completed successfully.

Failure codes:

= AutoLearn has not been carried out (default setting)

= AutoLearn failed, usually due to manual interruption

Not used

= AutoLearn failed, probably due to drive or compass failure

= AutoLearn failed, probably due to motor current limiting

= AutoLearn failed, probably due to boat spinning

Repeat the AutoLearn procedure (see SmartPilot X-5R Drive Installa-

tion & Setup Guide).

MOT POW

SWAPPED

Motor cables are connected to power terminals (and power cables

are connected to motor terminals) at Course Computer. Turn off

power and swap over connections.

Symptom Possible cause and remedy

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare

Raymarine GyroPlus Yaw Sensor Einstellungsanleitung Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Navigatoren Raymarine GyroPlus Yaw Sensor