Raymarine 425 Spezifikationen PDF herunterladen (Seite 58)

3-32 Raychart 425 Chartplotter

➤ To receive waypoints and route lists:

1. Display the Waypoint List as previously described, then select

WPT/ROUTE TRANSFER.

2. Select

RECEIVE WAYPOINTS and press ENTER; the text changes to

STOP RECEIVING and remains selected.

3. Initiate sending waypoints on the NMEA compatible equipment.

4. To stop waypoint transfer, press

ENTER.

Note: If either the Waypoint List or Route List becomes full, a warning is

displayed and the operation is terminated.

3.7 Using Tracks

The Track function is used to mark an on-screen trail that the vessel has

followed, as if it had left a visible fixed wake.

While the track is turned on, it is recorded in the display unit’s memory.

You specify the interval at which track points are made and a line is drawn

on-screen between each point. Up to 2000 track points can be saved in

total.

The track remains on-screen, even following a Power off/on, until the

track is cleared.

Using the SmartRoute function, a track can also be converted to and

saved as a route which is automatically reversed, ready for use as a return

voyage.

This section describes how to:

• Set up a track and specify the interval between track points.

• Clear the current track.

• Convert the track to a route (SmartRoute).

➤ To access the track controls:

1. From chart mode, press the PAGE key to display the chart set up

function bar (Figure 3-50):

Figure 3-50: Set Up Function Bar

2. Select TRACK SET UP to display the Track function bar (Figure 3-51):

D4694_1

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 113 114

Keine Kommentare

Raymarine 425 Spezifikationen Seite 58