Raymarine RayTech RNS 5.0 Bedienungsanleitung PDF herunterladen (Seite 39)

Interfacing RNS 35

Connecting to Ockam Instruments

RNS connects to Ockam instruments via the Ockam Model 050D RS-232 Interface (not

supplied). You must also set two switches on the Ockam unit.

You can connect RNS using any Ockam RS-232 interface, however for optimum

reliability of data transfer the Model 050D is recommended.

To connect to a Model 050D RS-232 interface:

1. On the interface, set switch

to 4.

2. Set switch

to D.

Connecting a USB C-Card Reader

This section describes connecting a USB C-Card reader to your PC system.

To install a USB C-Card reader to your PC:

1. Plug your C-Map USB C-Card reader into your computer.

2. Click

Start

on the computer taskbar. The pop-up menu is displayed.

3. Click

Control Panel

. The control panel is displayed.

4. Click

Add/Remove Hardware

. The Add/Remove Hardware wizard is displayed.

5. Click Next. Follow the on-screen instructions.

3. Connect the cables as follows:

Cable color Ockam 050D pin

Yellow (Rx) Pin 4

Black (SGnd) Not used

Green (Tx) Pin 2

Black (SGnd) Pin1

D6979_1

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46

Keine Kommentare

Raymarine RayTech RNS 5.0 Bedienungsanleitung Seite 39