Raymarine SmartPilot SPX-30 Installationshandbuch Seite 11
- Seite / 48
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 1: Before you begin 3
Commissioning process
• Check you have adhered to commissioning pre-requisites.
• Initial setup: switch on, system settings.
• Dockside calibration.
• Seatrial calibration.
• SmartPilot X system ready for use.
1.2 Certified installation
Raymarine recommends certified installation by a Raymarine approved installer. A
certified installation qualifies for enhanced warranty benefits. (See the separate
warranty card packed with your product.) For more information on certified installation
contact your Raymarine dealer or refer to the Raymarine web site:
www.raymarine.com.
1.3 Further assistance
Comprehensive customer support is available online and by telephone.
www.raymarine.com
In the Customer Service area you will find:
• Frequently Asked Questions (FAQs).
• Servicing information.
• Email access to the Raymarine Technical Support Department.
• Details of Raymarine agents worldwide.
Telephone helpline
In the USA
+1 603 881 5200 extension 2444
In the UK, Europe, the Middle East or the Far East
+44 (0) 23 9271 4713 (voice)
+44 (0) 23 9266 1228 (fax)
Help us to help you
When requesting service, please quote as much of the following product information
as possible:
• Product type
• Model number
• Serial number
• Software issue number
81287_1.book Page 3 Tuesday, March 18, 2008 11:50 AM
- ST70 Autopilot 1
- Controller 1
- SmartPilot X 1
- Commissioning 1
- Instructions 1
- Contents 3
- Warnings and cautions 5
- EMC guidelines 6
- Suppression ferrites 6
- EMC conformance 7
- Product disposal 7
- Chapter 1: Before you begin 9
- Commissioning pre-requisites 10
- 1.2 Certified installation 11
- 1.3 Further assistance 11
- 1.4 Product documents 12
- Switch on 14
- Initial setup 15
- Data units 16
- 2.2 Dockside calibration 17
- Drive setup 18
- Rudder check 18
- D10902-1 19
- D10900-1 19
- D10895-1 19
- Motor phasing check 20
- Dockside calibration complete 20
- 2.3 Seatrial calibration 21
- Compass swing 22
- Compass alignment to GPS 22
- Manual compass alignment 22
- 2.4 After commissioning 23
- 3.1 Introduction 25
- 3.2 Vessel settings 25
- Cruise speed 26
- 3.3 Drive / rudder settings 26
- Counter rudder 27
- Rudder damping 27
- Auto trim 28
- Auto turn (motor boats only) 28
- Response level 29
- Off course alarm 29
- Turn rate limit 30
- Joystick control 30
- Latitude compass damping 30
- Rudder limit 31
- Rudder offset 31
- Reverse rudder reference 31
- 3.4 Sailboat settings 32
- Wind selection 33
- WindTrim 33
- 34
- 4.1 Maintenance 35
- 4.2 Troubleshooting 36
- SeaTALK or SeaTalk ) 37
- Troubleshooting tools 40
- Technical support 41
- Glossary 43
- 36 ST70 User Reference Manual 44
- Specification 45
- 38 ST70 User Reference Manual 46
Panduit PN366E manuali
Manuali dei proprietari e guide per l'utente per Hardware Panduit PN366E.
We fornisce 1 manuali pdf Panduit PN366E per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Kommentare zu diesen Handbüchern