E-Series Networked DisplayInstallation ManualDocument Number: 87043_1Date: December 2004www.busse-yachtshop.de | [email protected]
iv E-Series Installation Manualwww.busse-yachtshop.de | [email protected]
Chapter 1: Preparation for installation 1Chapter 1: Preparation for installation1.1 General informationIntended useThis handbook provides information
2 E-Series Installation ManualContents of this packThe E- Series (E80 or E120) Networked Display pack contains the following items:Pack details
Chapter 1: Preparation for installation 3DimensionsThe dimensions for your E-Series display are:E80 Display E120 Display CANCE
4 E-Series Installation ManualAccessories and sparesRaymarine accessories and parts can be obtained from your authorized Raymarine dealer. However, if
Chapter 1: Preparation for installation 51.2 Planning the installationThis section provides information and advice for planning the installation of yo
6 E-Series Installation ManualSuppression Ferrites The illustration shows typical cable suppression ferrites used with Raymarine equipment.
Chapter 2: System Integration 7Chapter 2: System IntegrationIntroductionThis chapter provides an overview of system integration, you may find that you
8 E-Series Installation Manualdevices to talk to each other, whilst maintaining near transparent NMEA 2000 compatibility. What is SeaTalk High Speed?S
Chapter 2: System Integration 92.2 CompatibilityRadar ScannersCAUTION: Radar Scanners, Cables & InstallationInformation on radar scanners, cables
Trademarks and registered trademarksAutohelm, HSB, Raymarine, RayTech, RayTech Navigator, Sail Pilot, SeaTalk and Sportpilot are registered trademarks
10 E-Series Installation ManualMedia storage cardsNavionics Chart cardsTo use your E-Series Display as a navigation aid, charts with detailed informat
Chapter 2: System Integration 112.4 How is an E-Series integrated?You can integrate:• A single E-Series display.OR:• Connect two E-Series displays or
12 E-Series Installation ManualSingle display systemThis simple system incorporates a single E-Series display with a DSM 300 and radar. Po
Chapter 2: System Integration 13Networking E-Series DisplaysYou can connect two or more E-Series Displays to create a network. This will enable you to
14 E-Series Installation ManualA typical two node system incorporating two displays Power CablesRed 12V or 24V DCBlack 0VGround/Ea
Chapter 2: System Integration 15An example of a three (or more) node systemTo: Fast heading sensor NMEA GPS DSC radioTo: SeaTalk system Remote alarm
16 E-Series Installation Manualwww.busse-yachtshop.de | [email protected]
Chapter 3: Installation 17Chapter 3: InstallationCAUTION: Please ensure that you have read Chapter 1: Preparation for installation before proceeding.
18 E-Series Installation Manuali. Locate the front cover clip-on over the front of the display - see page 20.ii. Check that the buttons have passed th
Chapter 3: Installation 19Flush mounting the DisplayYou should flush mount your display as follows:.1. Check the selected location for the unit. A cle
Table of ContentsChapter 1: Preparation for installation ...11.1 General information
20 E-Series Installation ManualHow is the front cover clip-on attached to the display?The front cover clip-on is attached as follows: 1. C
Chapter 3: Installation 21How do I remove the front cover clip-on? To remove the clip- on front cover:1. To prevent damaging your dash or
22 E-Series Installation Manual3.2 CablesThis section details how to instal and connect all the relevant cables to your E-Series Display.Siting and se
Chapter 3: Installation 23How are the cables connected to the display?The cable connections are located on the back of the display unit. All cables ca
24 E-Series Installation ManualHow do I use the cable splicers?The cable splicers are used to make the connections between the cables easy and secure,
Chapter 3: Installation 25Extension cableIf an extension power cable is required, please note the following:• The wire gauge used may be affected by t
26 E-Series Installation ManualNMEA 0183 cable The NMEA 0183 cable is supplied with exposed wire connecting tails. These should be connected to your e
Chapter 3: Installation 27Composite source typeUse the supplied cable to connect up to 4 composite source inputs to your E-Series Display. The color o
28 E-Series Installation ManualRadar cable (not supplied)Having ensured that the radar scanner you are using is compatible with the E-Series Display (
Chapter 3: Installation 29The array and the display should be connected using the split pedestal cable as shown: ... to repla
Table of ContentsChapter 3: Installation ...173.1 How can th
30 E-Series Installation Manual Pedestal adaptor cable(2.5 metres)PAGEACTIVEWPTSMOBMENUDATACANCELOKRANGEINOUTD7328-1Open ArrayBoats DCPowe
Chapter 4: Commissioning the system 31Chapter 4: Commissioning the system4.1 IntroductionThis chapter details the commissioning of your E-Series Displ
32 E-Series Installation Manual4.3 Pre-start checksBefore you perform any functional tests, please carry out the following pre-start checks:Radar• Che
Chapter 4: Commissioning the system 334.4 Initial power on procedureOnce you have conducted the pre-start checks you are ready to start the display:
34 E-Series Installation Manual1. Press OK to select the highlighted page set.2. Press PAGE. The currently selected page set is represented on the sof
Chapter 4: Commissioning the system 35Bearing alignmentAdjusting the bearing alignment ensures that targets appear at the correct bearing relative to
36 E-Series Installation Manual3. With RADAR SET UP highlighted, use the trackpad (right) to display the RADAR SET UP menu.4. Use the trackpad (up/dow
Chapter 4: Commissioning the system 37This screen provides, for each tracked satellite, the satellite number, a graphical signal strength bar, status,
38 E-Series Installation Manual1. Without a chart card installed, press PAGE.2. Select a full window chart application by pressing the associated key.
Chapter 4: Commissioning the system 394.10 How do I test the video?To ensure that the video application is operating you should open a video applicati
Table of ContentsRadar alignment checks ...34Bearing alignment ...
40 E-Series Installation Manualwww.busse-yachtshop.de | [email protected]
Chapter 5: Troubleshooting 41Chapter 5: TroubleshootingIntroductionThis chapter provides information on troubleshooting your Raymarine E-Series Displa
42 E-Series Installation Manual5.2 How can I get Technical Support?Raymarine provides a comprehensive customer support service, on the world wide web,
Chapter 5: Troubleshooting 43How can I contact Raymarine in the US?You can contact Raymarine in the US either using the Raymarine world wide web as de
44 E-Series Installation ManualIf you wish to enquire about the repair status of your unit, contact the Repair Center at:1-800-539-5539How can I conta
Table of Contentswww.busse-yachtshop.de | [email protected]
Important Information iImportant InformationSafety noticesWARNING:Navigation aidThis product is intended to be used as an aid to navigation. Its accur
ii E-Series Installation ManualCAUTION: Radar Scanners, Cables & InstallationInformation on radar scanners, cables and their installation contain
Important Information iiiEMC ConformanceAll Raymarine equipment and accessories are designed to the best industry standards for use in the recreationa
Kommentare zu diesen Handbüchern